Get Engine Data from the Lowrance Elite Ti Graphs

Get Engine Data from the Lowrance Elite Ti Graphs


So we have the engine data cable hooked up
on our Yamaha engine on this boat. We’ve got that connected to our NMEA network and now what you can see is you can actually see on screen our engine
data. You can see we have RPMs, our water pressure, our speed over ground, our
voltage from our alternator. So all of this information comes right
here on your dash. Over here on the side, we’ve got our dash gauge. You can see as I
trim it up, it shows us where we’re at on trim. As I
trim it down again it shows us where we’re at. Now we know where full trim.
I’m going to step on the throttle here a little bit. You’ll see RPM speed up. You can see our speed go up also. We’ve got our
water temp and our depth on screen also. So these are a lot of features that are
really great. Using this feature you no longer have to
have all of the gauges on your dash you can run these gauges right on your unit.

7 thoughts on “Get Engine Data from the Lowrance Elite Ti Graphs

  • October 1, 2016 at 12:04 pm
    Permalink

    how do you set the engine hours?bluebonnet955

    Reply
  • January 29, 2017 at 6:09 pm
    Permalink

    This would be nice if the motor module wasn't $400

    Reply
  • October 27, 2018 at 2:38 am
    Permalink

    How about showing the hook up?

    Reply
  • February 26, 2019 at 2:35 am
    Permalink

    I have a 2005 Yamaha 225 four stroke. Can you till me what I would need to get information to my hds16?

    Reply
  • March 25, 2019 at 9:33 am
    Permalink

    Does Lowrance elite 5 ti have NMEA port.
    Thanks.

    Reply
  • July 16, 2019 at 8:20 pm
    Permalink

    Very happy with the purchase of this unit>>>allabout.wiki/4hxz as I was looking for something affordable that would give me a great bang for my buck and this was it!

    Reply
  • August 2, 2019 at 8:50 am
    Permalink

    Its there any way to reset engine running hrs for maintenance?

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *