Review of the CE SMIth Boat Guide Ons with LED Lights – etrailer.com

Review of the CE SMIth Boat Guide Ons with LED Lights – etrailer.com


Today we’re going to take a look at and show you how to install the CE Smith Post-Style Guide-Ons with LED Lights for Boat Trailers These are the 60″ tall version Part number is CE27760 Now let’s test them out We’ll just supply power to our trailer through our running light circuit and see if they work Perfect We’ve got the nice amber lights facing forward then we’ll have the red lights on the rear Our heavy-duty post guides do a real good job of helping us get our boats on and off of our trailer

12 thoughts on “Review of the CE SMIth Boat Guide Ons with LED Lights – etrailer.com

  • June 21, 2017 at 4:51 pm
    Permalink

    Two years late but well done on the video. Thanks

    Reply
  • July 20, 2017 at 12:10 am
    Permalink

    Very nicely done.

    It seems there would be a temptation to run the wires inside the hole of the lance (on the outside) and then run the wires straight through the rest of the tube, but that could cause chafing issues.

    Reply
  • October 13, 2017 at 5:22 pm
    Permalink

    I like this. thanks.

    Reply
  • July 19, 2018 at 7:59 pm
    Permalink

    I couldn’t get the pvc posts to “slip” over the uprights — they would bind up 1/3 of the way down and then were really hard to take off. I emailed the company — no response. Finally, I just took a hand-held grinder and ground down the corners of the uprights all the way down to bottom. Then the posts “slipped” onto the uprights.

    Reply
  • September 10, 2018 at 7:50 pm
    Permalink

    good job!

    Reply
  • December 22, 2018 at 3:39 pm
    Permalink

    Are the ubolts and nuts/washers stainless steel? I would be using this in salt water and galvanized fasteners always rust, no matter what.

    Reply
  • December 29, 2018 at 10:31 am
    Permalink

    expired tag,lol

    Reply
  • April 27, 2019 at 6:50 pm
    Permalink

    how do i find that kit on your website?

    Reply
  • June 15, 2019 at 5:28 am
    Permalink

    Good video !! Didn't care too much for the slide on poles . Anyone can just walk by and pull them off . Put screws in ours to prevent that !! I'm sure there made to pop off in an emergency but in bad stiff current i would rather they stay on . If they break ? They break . Oops . Better than a big gash in the side of the boat . Just saying

    Reply
  • June 23, 2019 at 5:32 pm
    Permalink

    I’d run the wires through the guide poles. Correctly looming them and securing them will prevent any damage to the coating of the wires.

    Reply
  • July 9, 2019 at 5:08 am
    Permalink

    Not sure I’ll hear back but I followed this great video to a ‘T’ but my lights do not work??!! I tested lights individually on a battery before hooking up and they both work. My Shorlamder trailer is 2007 with lED lights do not sure if direction of current matters? Galvanized aluminum trailer. Is there a way to cheat the ground… splicing to white or back to brown?

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *